Sample Tubes
for Sample Probes
Series ASP
AST 400
with G
3/4"-connection thread
Application
These sample tubes
are used in combination with the Ankersmid ASP probes in order to sample
the gas in the best section of the gas-stream. Typical advise is to install the
probe-tip in the middle third of the gas stream.
For dust
concentrations higher than 2g/m³, we advise to take a pre-filter in combination
with an extension tube.
Different
situations:
|
Situation |
Type |
Max.T°
[°C] |
Material |
Connect |
Outer
diam. |
|
Temp<150°C |
ASP-PT |
150° |
PTFE |
G3/4 |
22 |
|
After wet
scrubber or high dew point |
ASP-Dem |
90° |
PTFE
and
PVDF |
G3/4 |
40-70 |
|
Temp<600°C |
ASP-SS |
600° |
316
L |
G3/4 |
22 |
|
Temp<900°C |
ASP-HC |
900° |
HastelloyC® |
G3/4 |
22 |
|
Temp<1400°C |
ASP-Kant |
1400° |
Kanthal® |
G3/4 |
20 |
|
Hcl or high
corrosive gas |
ASP-Ti |
450° |
Titane |
G3/4 |
22 |
Maximum sample Tube
temperature is depending of the horizontal length that is inside this
temperature zone !